Remove the light assembly cover
by pulling its outside edge.
Open the trunk.
Test the new bulb to make sure it
works.
Push a new bulb straight into the
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Reinstall the light assembly cover.
Determine which of the three
bulbs is burned out: stop/taillight,
rear side-marker, or turn signal
light.
Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
5.
6.
3.
4.
1.
2.
7.
Lights
Replacing Rear Bulbs
(In Fenders)
436
COVER
０８／０２／０６ ２１：３６：０１ ３１ＴＬ１６００ ０４４１
To Next Page
Loading...
Need help?
General
