Place the flat tire face down in the
spare tire well.
Remove the spacer cone from the
wing bolt, turn it over, and put it
back on the bolt.
To remove the spacer cone,
squeeze the tabs on the wing bolt
to disengage it from the center of
the spacer cone, then pull the bolt
downward.
To install the wing bolt to the
spacer cone, reverse this
procedure.
Store the center cap in the trunk.
Make sure it does not get
scratched or damaged.
Unhook the handle from the trunk
opening and lower the trunk floor
lid, then close the trunk lid.
Your vehicle’s original tire has a
tire pressure monitoring system
sensor. To replace a tire, refer to
(see
page ).
Store the jack and tools in the tool
kit case. Place the tool kit case in
the flat tire.
Securetheflattirebyscrewing
the wing bolt back into its hole.
19.
16.
17.
20.
396
21.
18.
Changing a Tire with TPMS
Changing a Flat Tire
Taking Care of the Unexpected
463
WING BOLT
For normal tire
SPACER CONE
For compact spare tire
SPACER CONE
TAB
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
０８／０２／０６ ２１：４０：１０ ３１ＴＬ１６００ ０４６８
To Next Page
Loading...
Need help?
General
