Customized Settings
With the multi-information display
and the INFO (
/ ) and SEL/
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings.
To enter the customizing mode,
press and hold the INFO (
/ )
button for more than 3 seconds.
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park.
You cannot customize the settings
under these conditions:
●
If you turn the ignition switch to
the ACCESSORY (I) or the LOCK
(0) position.
●
If you move the shift lever out of
Park.
The first customizing menu is:
●
DEFAULT ALL
●
CHG SETTING
If you want the settings as they were
when the vehicle left the factory,
select DEFAULT ALL, as described
on page 85.
If you want to change any vehicle
control settings, select CHG
SETTING, then press the SEL/
RESET button (see page 86).
Refer to the table on the following
pages about the settings you want to
customize.
Multi-Information Display
82
09/07/07 15:02:04 10 ACURA RDX MMC North America Owner's M 50 31STK630 enu
To Next Page
Loading...
Need help?
General
