Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb by turning it one-
quarter turn counterclockwise.
Use a Phillips-head screwdriver to
remove the two undercover bolts,
and remove the holding clip with a
flat-tip screwdriver.
Carefully push up the side under
cover into the bumper.
Your vehicle uses halogen light
bulbs. When replacing a bulb, handle
it by its plastic case, and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with denatured alcohol and a
clean cloth.
Thefoglightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
trunk or pull a trailer, readjustment
may be required. Adjustment should
be done by your dealer or another
qualified technician.
3.
4.
1.
2.
Lights
ReplacingaFogLightBulb
472
CLIP
CONNECTOR
BOLTS
BULB
Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass
can cause the bulb to overheat and
shatter.
11/07/20 19:02:22 31SJA670_477
To Next Page
Loading...
Need help?
General
