Acura CL 2003 User Manual

Both front seats are equipped with
seat heaters. The ignition switch
must be ON (II) to use them. Push
the heater switch to turn the power
on or off. The pilot lamp lights and
remains on while the heaters are on.
Do not use the seat heaters when the
engine is off or when idling for a
long period of time. They can drain
the battery, making your car hard to
start.
Because of the sensors for the side
airbag system, there is no heater in
the passenger’s seat-back.
Each door has a switch that controls
its window. To open the window,
push the switch down and hold it.
Release the switch when you want
the window to stop. Close the
window by pulling back on the
switch and holding it.
Your car’s windows are electrically-
powered. Turn the ignition switch to
ON (II) to raise or lower either
window.
With M/T
Instruments and Controls
Seat Heaters, Power Windows
Power Windows
104
SSEEAATT HHEEAATTEERRSS
０２／０１／０９ １４：０８：２７ ３１Ｓ３Ｍ６２０ ０１０７

Acura CL 2003 Specifications

General

Brand	Acura
Model	CL 2003
Category	Automobile
Language	English