The power window system has a key-
off delay function. The windows will
stilloperateforuptotenminutes
after you turn off the ignition.
Opening either door cancels the
delay function. You must turn the
ignition switch ON (II) again before
you can raise or lower the windows.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
If the driver’s window runs into any
obstacle while it is closing
automatically, it will stop, and then
reverse direction. To close the
window, remove the obstacle, then
use the window switch again.
The MAIN switch controls power to
the passenger’s window. With this
switch off, the passenger’s window
cannot be raised or lowered. The
MAIN switch does not affect the driv-
er’s window. Keep the MAIN switch
offwhenyouhavechildreninthecar
so they do not injure themselves by
operating the window unintentionally.
The lights inside the switches come
onwhenyouturntheparkinglights
or headlights on.
If your car’s battery is disconnected
or goes dead, or the driver’s window
fuse is removed, the AUTO function
will be disabled. The power window
system needs to be reset after
reconnecting the battery or installing
the fuse. You should do the following.
Start the engine. Push down on
the driver’s window switch until
the window is fully open.
If the power windows do not operate
properly after resetting, have your
car checked by an Acura dealer.
Pull back on the driver’s window
switch to close the window
completely, then hold the switch
for a second or two more.
2.
1.
Instruments and Controls
Power Windows
Auto Reverse
106
０２／０１／０９ １４：０８：４６ ３１Ｓ３Ｍ６２０ ０１０９
To Next Page
Loading...
Need help?
General
