CONTINUED
Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
When the coolant stops draining,
tightenthedrainplugatthe
bottom of the radiator.
Tighten the drain bolt at the rear
of the engine cylinder block
securely.
Tightening torque:
Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator up to the base of the
filler neck. This coolant is a
mixture of 50 percent antifreeze
and 50 percent water. Pre-mixing
is not required.
The cooling system capacity is:
Start the engine and let it run for
about 30 seconds. Then turn off
the engine. Pour coolant into the
radiator up to the base of the filler
neck.
7.
8.
9. 10.
Cooling System
Maintenance
247
FFIILLLLEERR NNEECCKKFFiillll uupp ttoo hheerree
RREESSEERRVVEE TTAANNKK
7 lbf·ft (10 N·m , 1.0 kgf·m)
1.48 US gal (5.6
, 1.23 Imp gal)
０２／０１／０９ １４：３１：３３ ３１Ｓ３Ｍ６２０ ０２５０
To Next Page
Loading...
Need help?
General
