Acura CL 2003 User Manual

This light comes on with the high
beam headlights. See page for
information on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page ).
This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch off and the
parking brake set. It should go off if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
The left or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page ). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
WhenyouturnontheHazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the car should flash.
The appropriate light comes on in
this display if the trunk or either
door is not closed tightly with the
ignition switch ON (II).
277
70
72
Canadian models only
High Beam Indicator
‘‘Daytime Running
Lights’’ Indicator
Turn Signal and
Hazard Warning
Indicators
Door and Trunk Open Monitor
Indicator Lights
Instruments and Controls
63
０２／０１／０９ １４：０２：１１ ３１Ｓ３Ｍ６２０ ００６６

Acura CL 2003 Specifications

General

Brand	Acura
Model	CL 2003
Category	Automobile
Language	English