99
uuIndicatorsu
Continued
Indicator Name On/Blinking Explanation
System Message
Indicator
• Comes on along with a beep when a
problem is detected. A system message on
the driver information interface appears at
the same time.
• While the indicator is on, roll the right selector
wheel to see the message again.
2 Switching the Display P. 109
• Refer to the Indicators information in this chapter
when a system message appears on the driver
information interface. Respond to the message
accordingly.
• The driver information interface will not return to
the normal screen unless the warning is canceled,
or the right selector wheel is rolled.
Adaptive Cruise
Control (ACC)
with Low Speed
Follow Indicator
(Amber)
●
Comes on if there is a problem with ACC
with Low Speed Follow.
●
Comes on while driving - Have your vehicle
checked by a dealer.
●
Indicator may come on temporarily when the
Maximum Load Limit is exceeded.
●
ACC with Low Speed Follow has been
automatically canceled.
●
Make sure the total load is within the Maximum
Load Limit.
2 Maximum Load Limit P. 419
●
Stays on constantly - Have your vehicle checked
by a dealer.
●
Comes on if the ACC is deactivated
temporarily after the battery has been
disconnected, then re-connected.
●
Drive a short distance at more than 12 mph (20
km/h). The indicator should go off. If it does not,
have your vehicle checked by a dealer.
22 ACURA MDX-31TYA6000_02.book 99 ページ ２０２０年１１月５日 木曜日 午前１１時３９分
To Next Page
Loading...
Need help?
General
