Continued
137
uuLocking and Unlocking the DoorsuLocking/Unlocking the Doors from the Outside
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driver’s door.
3. Using the master door lock switch, operate
the lock as follows:
Lock Unlock Lock Unlock.
u The beeper sounds and the function is
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle without using the auto lock
function.
• With the keyless access remote on you,
move out of the auto lock function
operation range.
• Open any door.
1Locking the doors and tailgate (Walk away auto lock®)
If you use the power tailgate walk away close
function when all the doors are closed, the auto lock
function will also be activated.
uWhen you walk away from the vehicle while the
power tailgate is automatically closing, it will
continue to lock automatically.
2 Power Tailgate Walk Away Close
*
P. 151
If equipped, the user must wait until the power
tailgate fully closes before the auto lock function will
be activated.
The auto lock function does not operate when any of
the following conditions are met.
• The keyless access remote is inside the vehicle.
• A door, tailgate or the hood is not closed.
• The power mode is set to any mode other than
OFF.
• The keyless access remote is not located within a
radius of about 5 feet (1.5 m) from the vehicle
when you get out of the vehicle and close the
doors and tailgate.
Models with power tailgate walk away close
* Not available on all models
22 ACURA MDX-31TYA6000_02.book 137 ページ ２０２０年１１月５日 木曜日 午前１１時３９分
To Next Page
Loading...
Need help?
General
