Continued
483
uuAcuraWatch
TM
uCollision Mitigation Braking System
TM
(CMBS
TM
)
When you turn the CMBS
TM
on and off, do the
following.
1. Press the safety support switch.
2. Roll the right selector wheel to the
symbol and push it.
u The message appears on the driver
information interface when the system
becomes on or off.
u A check mark appears in the box and the
color of the symbol changes green
when the system is on. The check mark
disappear and the color of the
symbol changes gray when the system is
off.
The CMBS
TM
is turned on every time you start
the engine, even if you turned it off the last
time you drove the vehicle.
■
CMBS
TM
On and Off
1Collision Mitigation Braking System
TM
(CMBS
TM
)
The CMBS
TM
may automatically shut off, and the
safety support indicator (amber) will come and stay
on under certain conditions:
2 CMBS
TM
Conditions and Limitations P. 484
You can also select the safety support content from
the driver information interface.
2 Driver Information Interface (Right Side
Area) P. 108
When the CMBS
TM
is activated, it will continue to
operate even if the accelerator pedal is partially
depressed.
However, it will be canceled if the accelerator pedal is
fully depressed.
The vehicle stability assist
TM
(VSA®) system, adaptive
cruise control (ACC) with low speed follow, safety
support and low tire pressure/TPMS indicators may
come on in amber along with a message in the driver
information interface when you set the power mode
to ON after reconnecting the battery.
Drive a short distance at more than 12 mph (20 km/h).
Each indicator should go off. If any do not, have your
vehicle checked by a dealer.
Have your vehicle checked by a dealer if you find any
unusual behavior of the system (e.g., the warning
message appears too frequently).
Right Selector Wheel
Safety Support Switch
22 ACURA MDX-31TYA6000_02.book 483 ページ ２０２０年１１月５日 木曜日 午前１１時３９分
To Next Page
Loading...
Need help?
General
