uuIf a Tire Goes FlatuChanging a Flat Tire
640
1. Push the rear edge of the handle on the
floor lid and open the lid.
2. Turn the knobs counter-clockwise to
remove the tool case cover.
3. Unstrap the jack and take out of the tool
case. Remove the wheel nut wrench and
jack handle bar from the tool case cover.
4. Remove the square-shaped cover on the
cargo area lining.
u Wrap the flat-tip screwdriver with a
cloth to prevent scratches.
■
Getting Ready to Replace the Flat Tire
Do not use the jack if it doesn’t work properly. Call
your dealer or a professional towing service.
The wheel nut wrench supplied with your vehicle is
specially adapted to fit the holder shaft. Do not use
any other tool.
22 ACURA MDX-31TYA6000_02.book 640 ページ ２０２０年１１月５日 木曜日 午前１１時３９分
To Next Page
Loading...
Need help?
General
