667
uuIf the Battery Is Deadu
5. Connect the other end of the second
jumper cable to the ground bolt as shown.
Do not connect this jumper cable to any
other part.
6. If your vehicle is connected to another
vehicle, start the assisting vehicle’s engine
and increase its rpm slightly.
7. Attempt to start your vehicle’s engine. If it
turns over slowly, check that the jumper
cables have good metal-to-metal contact.
Once your vehicle’s engine has started, remove the jumper cables in the following
order.
1. Disconnect the jumper cable from your vehicle’s ground.
2. Disconnect the other end of the jumper cable from the booster battery -
terminal.
3. Disconnect the jumper cable from your vehicle’s battery + terminal.
4. Disconnect the other end of the jumper cable from the booster battery +
terminal.
Have your vehicle inspected by a nearby service station or a dealer.
■
What to Do After the Engine Starts
1Jump Starting Procedure
The Vehicle Stability Assist
TM
(VSA®) system, Adaptive
Cruise Control (ACC) with Low Speed Follow, safety
support, and low tire pressure/TPMS indicators may
come on along with a message in the driver
information interface when you set the power mode
to ON after reconnecting a battery.
Drive a short distance at more than 12mph (20 km/h).
Each indicator should go off. If any do not, have your
vehicle checked by a dealer.
22 ACURA MDX-31TYA6000_02.book 667 ページ ２０２０年１１月５日 木曜日 午前１１時３９分
To Next Page
Loading...
Need help?
General
