89
uuIndicatorsu
Continued
Indicator Name On/Blinking Explanation
Malfunction
Indicator Lamp
• After you have set the power mode to ON,
the vehicle performs system checks.
However, if the readiness codes have not
been set by that time, this indicator will blink
five times and then go off.
• Readiness codes are part of the on board
diagnostics for the emissions control systems.
2 Testing of Readiness Codes P. 695
●
Comes on if there is a problem with the
emissions control systems.
●
Blinks when a misfire in the engine’s
cylinders is detected.
2 If the Malfunction Indicator Lamp Comes On
or Blinks P. 671
Charging System
Indicator
• Comes on when there is a problem with the
charging system.
• Stop in a safe place and have your vehicle checked
by a dealer immediately.
2 Checking the Battery P. 624
2 If the Charging System Indicator Comes On
P. 671
Gear Position
Indicator
• Indicates the current gear selection.
2 Shifting P. 442
M (sequential
mode) Indicator/
Sequential Mode
Gear Selection
Indicator
• Comes on when the sequential mode is
applied.
2 Sequential Mode P. 448
22 ACURA MDX-31TYA6000_02.book 89 ページ ２０２０年１１月５日 木曜日 午前１１時３９分
To Next Page
Loading...
Need help?
General
