EasyManuals Logo

Acura MDX User Manual

Acura MDX
687 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #183 background imageLoading...
Page #183 background image
Continued
181
uuOperating the Switches Around the Steering WheeluAuto High-Beam
Controls
To activate the system, turn the headlight
switch to AUTO and then set the headlights
to low beam. The auto high-beam indicator
will come on.
2 Light Switches P. 176
The high beams remain on unless:
You have been driving below 25 mph (40 km/h) for an extended amount of time.
The speed of the vehicle drops below 15 mph (24 km/h).
The windshield wipers have been running at a high speed for more than a few
seconds.
You enter a well lit location.
The high beams come back on once the condition that caused them to turn off no
longer exists.
If needed, you can temporarily turn the system off manually. Turn on the high
beams by pushing the lever forward until you hear a click, or flash the high beams
once by pulling the lever towards you. To turn the system back on, repeat one of the
procedures.
Operating the System
1Operating the System
For the auto high-beam to work properly:
Do not place an object that reflects light on the
dashboard.
Keep the windshield around the camera clean.
When cleaning the windshield, be careful not to
apply windshield cleanser to the camera lens.
Do not attach an object, sticker or film to the area
around the camera.
Do not touch the camera lens.
If the camera receives a strong impact, or repairing of
the area near the camera is required, consult a dealer.
If the Some Driver Assist Systems Cannot
Operate: Camera Temperature Too High message
appears:
Use the climate control system to cool down the
interior and, if necessary, also use defroster mode
with the airflow directed towards the camera.
Start driving the vehicle to lower the windshield
temperature, which cools down the area around
the camera.
If the Some Driver Assist Systems Cannot
Operate: Clean Front Windshield message
appears:
Park your vehicle in a safe place, and clean the
windshield. If the message does not disappear after
you have cleaned the windshield and driven for a
while, have your vehicle checked by a dealer.
Headlight
Switch
18 ACURA MDX E-AWD-31TRX6100.book 181 ージ 017年11月10日 金曜日 午前0時21

Table of Contents

Other manuals for Acura MDX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Acura MDX and is the answer not in the manual?

Acura MDX Specifications

General IconGeneral
BrandAcura
ModelMDX
CategoryAutomobile
LanguageEnglish

Related product manuals