BETA BRITE Programming Manual
6 Basic sign operation: Turning a sign on and off
Basic sign operation
Turning a sign on and off
When you plug in the sign’s power supply, the sign starts up
automatically, and unplugging the power supply turns the sign off.
However, instead of unplugging a sign, there is another way to turn
the sign off:
Holding down
FCN
and then press
PROGRAM
turns a sign off and on.
NOTE: Messages that you have programmed into the sign will
not
be
lost when you turn a sign off. Messages will be retained for
up to 30 days if the sign is not powered.
When a signs starts up, the following will be displayed:
1036-0001A
THEN
32K RAM
The software (or “firmware”) version inside the sign.
WED 1:26 PM
THEN
The amount of memory inside the sign.
The time and date of the sign.
To Next Page
Loading...
Need help?
General