Remote Control Programming Manual
4 Basic sign operation: Setting a sign’s time and date
Setting a sign’s time and date
Once set, a sign will remember the time and date unless the sign is
unplugged or interrupted by a power loss.
NOTE: Because the BetaBrite
®
sign does not have a real-time clock,
the date function can not be updated when power is off. The
date and time must be re-programmed whenever the sign
loses power for any reason.
Step When you do this... You see this...
1 Press PROGRAM.
2 Press BACK until SET TIME appears.
3 Press ADV.
4
Press D to set the day of the week.
Press H to set the hour.
Press M to set the minute.
NOTE:Press SELECT, to change from 12-hour
(AM/PM) to 24-hour mode (0 - 23).
5 Press BACK until SET DATE appears.
6 Press ADV.
7
Press D to set the correct day.
Press M to set the month.
Press Y to set the year.
NOTE:Press SELECT to display the date in
different formats—for example, JAN 26,
2001 or 1/26/01, or 26/1/01, etc.
8 After setting the date and time, press RUN twice to return to normal operation.
PROG TEXT A
SET TIME
SET W/D ,H&M
THEN
MON 2:29 AM
TUE 11:21 AM
SET DATE
SET WITH D,M,&Y
THEN
JAN. 19, 2006
1/19/06
To Next Page
Loading...