19
5.11. Using the AC Adapter
You may also operate this monitor using the AC adapter (output 6V DC/600 mA
with DIN plug).
Use only the approved ADC
®
AC adapter to avoid damaging the unit.
a) Ensure that the AC adapter and cable are not damaged.
b) Plug the adapter cable into the AC adapter port on
the right side of the blood pressure monitor.
c) Plug the adapter into your electrical outlet.
When the AC adapter is connected, no battery current
is consumed.
Note: No power is taken from the batteries while the AC
adapter is connected to the monitor. If electrical power is
interrupted, (e.g., by accidental removal of the AC adapter from the outlet) the
monitor must be reset by removing the plug from the socket and reinserting the
AC adapter connection. If you have any questions regarding the AC adapter
please call 1-800-232-2670.
6. Software Functions (6022, 6023 only)
This unit can be used in connection with your
personal computer (PC) running the ADC
®
Advanced PC Link Software. Your PC will
allow a capacity of monitoring 80 patients,
each with 1000 records of data (Note: Over-
use will lower system efficiency).The memory
data can be transferred to the PC by connect-
ing the monitor via the included USB cable
with your PC. Note: The software does not
work with Mac computers.
6.1. Installation and Data Transmission
a)Insert CD into CD ROM drive of your PC. The
installation will start automatically. If not, click on SETUP.EXE.
b)Connect the monitor via USB cable with the PC. Three horizon-
tal bars will appear on the display and last for 3 seconds.
c)The bars will then flash to indicate that the connection between
computer and device is successfully made. As long as the cable
is plugged, the bars will keep flashing and the buttons are dis-
abled.During the connection, the device is completely
controlled by the computer. Refer to the ‘Help’ file in the soft-
ware for detailed instructions.
1
---
1
---
To Next Page
Loading...
