ADE WS 2324 - Base Station; General Information; Start-Up; Wireless Outdoor Sensor

40
Weather station WS 2324
Start-up
General Information
 Proceed according to the order listed below and first
insert the batteries into the wireless outdoor sensor.
Only then can the weather station function without
flaws.
 Do not use rechargeable batteries, since their
voltage is too low (only 1.2 V instead of 1.5 V). This
affects, among other things, the precision of the
measurements.
 Where possible, use alkaline rather than zinc-carbon
batteries. Alkaline batteries last longer, especially at
low outdoor temperatures.
Wireless outdoor sensor
1. Remove the battery compartment cover on the back
of the outdoor sensor.
2. Insert two LR03/R3 (AAA) batteries as shown on the
bottom of the battery compartment. Observe the
correct polarity (+/-).
3. Replace the battery compartment cover.
Base station
Battery operation
1. Press in the locking tab of the battery compartment
cover and remove the cover.
2. Insert two LR03/R3 (AAA) batteries as shown on the
bottom of the battery compartment. Observe the
correct polarity (+/-).