ADE WS 2324 - Starting Signal Reception

41
Weather station WS 2324
3. Close the battery compartment again.
The locking tab must audibly engage.
All symbols will be displayed briefly for about
2seconds, followed by the indoor temperature
display.
4. Wait about 3minutes.
This is the time required for the base station to
connect to the outdoor sensor and receive radio
signals from the time signal transmitter.
Starting signal reception
As soon as the base station is supplied with current, all
of the indicators on the display will be shown for a brief
moment.
17:10
11
28
6
c
3
FRIDAY
M
D
OUTDOOR TEMP
26
6
c
The device then switches to receiving-mode,
during which the number of radio waves
indicates the quality of the reception: The more
radio waves shown on the display, the better is
the reception.
 Temperature data received by the wireless outdoor
sensor will appear on the display after a short time.
From now on, this data will be transmitted several
times a minute and constantly updated.
 Indoor temperature measurements from the base
station will be displayed at the bottom.
 As soon as the signal from the time signal transmitter
has been received with sufficient strength, the
corresponding data and the radio tower symbol are
English