42
Weather station WS 2324
shown permanently on the display. This process can
take a few minutes.
From now on, the weather station automatically switches
to receiving-mode multiple times each night. During
this process, the displayed time is compared with that
received from the time signal transmitter and, if necessary,
corrected.
If no sufficiently strong signal has been received,
the base station aborts the receiving process after a few
minutes and the radio-tower symbol goes out. The base
station restarts signal reception on the next full hour, up
to 5 times.
In this case, the time proceeds as usual (beginning with
the start time of “00:00”).
Checklist when data is missing on the display
No data display from the time signal transmitter
1. Check whether the location of the base station is
suitable; see “Choosing a location”.
2. Manually restart the receiving process, see
"Starting signal reception manually".
3. Wait until the base station automatically switches
back to reception at a later time. The reception is
usually better at night.
4. If signal reception is not possible at your location,
make settings manually as described in “Manual
configuration”.
To Next Page
Loading...
