EasyManua.ls Logo

Adexa ZBS-15 - Caring

Adexa ZBS-15
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note: when temperature lower than 15degrees,S/SMALL is recommended,when temperature over
30degrees,L/LARGE ice is recommended.
Step 6
Ice making cycle begins,ice will be frozen onto the evaporator fingers.
Step 7
Once ice making cycle is finished,the water tray will tilt forward; the remaining water flows back to the
water reservoir and the ice cubes will drop from the fingers.
Step 8
In about 15-35 seconds, the water tray will tilt backward,ice will be pushed to ice reservoir directly,unit
back to work from step 4 to step 6 again
Step 9
Push the ice cube dispenser puncher button to get ice, the indicator will be on
Note: Please put your cup below the ice cube dispenser shoot directly.
Notice: If the ice is stored in the unit for long time,the ice may freeze and stick together,then no ice will
be
dispensed even the ice is full,if so,please kindly use scoop included in the unit to break the ice
first,then push the puncher button.
Step 10
Press the ,unit start to dispense crushed ice,press it again,the unit will stop crushed
ice in 5seconds.
Step 11
Press ON/OFF button to turn off power of unit
Step 12
Push the puncher at left side of the unit,cold water will come out
Note: if you need to get cold water,at least the ice making function should be turn on.
Please make sure your cup is below the cold water outlet,or water will be splashed every where
Step 12
If you need to take off the pipe,replace it or insert the anti drain plug,please do as follows:
Firstly take off the blue ring named as A,then press the white ring(lock) at the outer side named as B,At
last take out the pipe
Caring
1.Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When
cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean
the inside and the outside surface of the ice maker. Do not spray ice maker with chemicals or diluted
agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2.Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do