23
4. Press D to stop chronograph; press and hold D to reset to zero when the
chronograph is stopped.
5. Press and hold A to save data to MY LOG.
MY LOG MODE
1. Press B to change to my log mode.
2. Press E to view data within the selected SET.
3. Press and hold E to race against any SET. This will put you in SHADOW RACE mode.
4. Press D to advance through saved sets.
5. Press and hold D to clear selected set. Continue holding to clear all sets.
NOTE: You can save up to 100 total laps in the memory.
SHADOW RACING
This function allows you to easily race against yourself from a previously stored
session of data that can be found under “MY LOG.” Take a lap reading at the marker
and the watch will tell you how you compare to your previous race.
1. Press B to change to MY LOG mode.
2. Press D to select set of data to race against.
3. Press and hold E to enter shadow racing chronograph.
4. Press C to start shadow race mode.
5. Press and hold A to save run data when the chronograph is stopped.
NOTE: Shadow race mode will beep 5 seconds before reaching previous stored lap time.
ALARM MODE
1. Press B to change to alarm mode.
2. Press D to toggle between alarms 1 and 2.
3. Press E to toggle alarm on/off.
4. Press and hold A to set the alarm.
5. Press E to increase setting value. Press D to decrease setting value.
6. Press B to set and advance to next setting value.
7. Setting sequence is hour, minute, T1-T2.
8. Press A to save data and exit setting mode.
NOTE: Alarm status will be ON automatically after exit the ALARM SETTING mode. No
button operation for 60 seconds will auto-exit with changes saved, but alarm status OFF.
To Next Page
Loading...