39
(6) Preheating ok，star printing：
6.5Printing finish，take the model：
After finish printing，waiting platform cooling,take the model（Lateral
output makes it easier to remove the model）Observe, measure
七、Printer operating：
7.1Replace filament：
Please refer to the following steps to standardize the operation
Note: need to be heated to the melting temperature of the printer
supplies replacement supplies (such as PLA need to be heated to 200
DEG C), and then press the lever supplies downward after a period of
pull out, prevent the residual material supplies card to the channel, and
print out material inserting effect. The ejector pin of the machine is
used for dredging the runner.
To Next Page
Loading...
