ADJ FLAT PAR TW12 - Operating Instructions Overview; DMX Control Mode Setup

Flat Par TW12 Operating Instructions
ADJ Products, LLC - www.adj.com - Flat Par TW12 User Manual Page 8
The display will lock after 30 seconds, press the MENU button for 3 seconds to unlock.
LED Display On/O:
To set the LED display to turn o after 10 seconds, press the MODE button until “don” is displayed,
then press the UP button to display “do”. Now the display will disappear after 10s. Press any but-
ton to turn the display on again. Be advised though that the display will turn o automatically after
10 seconds.
To set the display press the MODE button until “dXX” is displayed. “XX” represents either “on” or
“oFF” Use the UP or DOWN buttons to select either:
“don” = LED display on at all times.
“doFF” = LED display shuts o after 10 seconds.
LED Display Inversion:
Follow these instructions to ip the display 180° so that the display can be read upside down.
1. Plug the xture in and press the MODE button until “dXX” is displayed. “XX” represents either
“on” or “oFF”.
2. Press the SET UP button until “Stnd” is displayed.
3. Press the UP or DOWN buttons to reverse the display 180°.
Operating Modes:
The Flat Par TW12 has ve operating modes:
• Sound-Active mode - The unit will react to sound, cycling through the built in programs.
• Static Color Mode - There are 32 colors to choose from.
• Auto Run Mode - There are 3 Auto Modes to choose from.
• WW/CW/A Dimmer Mode - Choose one of the three colors to remain static, or adjust the intensity
of each color to create your desired color.
• DMX control mode - This function will allow you to control the xture with a standard DMX 512
controller.
DMX Mode:
Operating through a DMX controller gives the user the freedom to create programs tailored to their
own individual needs. The Flat Par TW12 has 6 DMX modes: 2 Channel mode, 3 Channel mode, 4
Channel mode, 5 Channel mode, 8 Channel mode, and a 9 Channel mode.
1. This function will allow you to control each individual xture’s traits with a standard DMX 512
controller.
2. To run your xture in DMX mode press the MODE button until “d.XXX” is displayed. “XXX” repre-
sents the current displayed address. Use the UP or DOWN buttons to select your DMX Channel
mode.
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes.
4. See the Channel Mode sections of this manual for the DMX values and traits of each channel
mode.
5. After you have chosen your desired DMX Channel mode plug in the xture via the XLR connec-
tions to any standard DMX controller.