ADJ FOCUS SPOT 2X - Page 20

ADJ Products, LLC - www.adj.com - Focus Spot 2X User Manual Page 19
Focus Spot 2X System Menu
DMX ADDRESS - In this submenu you can nd and set your desired DMX address.
DMX CHANNEL MODE - In this submenu you can find and set your desired DMX channel mode.
SECONDARY MODE - In this submenu you are able to designate the unit(s) as either a “primary” or
“secondary” in a primary-secondary setup.
SHOW MODE - In this submenu you can select 1 of 5 (0-4) built-in shows to run.
TARGET MODE - In this submenu you are able to select 1 or 5 (0-4) target modes for the unit to
follow. Target mode is a restrictive pan/tilt control mode limiting the pan/tilt movements to a certain
degree. See page 24 for a diagram of the Target mode movements.
SOUND MODE - In this submenu you can activate and deactivate sound active mode.
SOUND SENSE - In this submenu you can adjust and set the sound sensitivity level for sound active
mode.
DMX STATE - This submenu setting is used as a precaution mode in case the DMX signal is
lost or interrupted. The operating mode chosen in this submenu is the running mode the xture
will go into when the DMX signal is lost. Listed below are the 3 modes.
• Pri/Sec Mode - This setting will have the fixture automatically go into primary/secondary
setup. The unit will go into the setting that is selected under “SECONDARY MODE”.
• Blackout - This setting will have the fixture automatically go into stand by mode (blackout).
• Last State - This setting will have the fixture stay in the last DMX setup.
DIMMER CURVE - In this submenu you are able to select 1 or 5 dimmer curves. See page 25 for the
dimmer curve chart for more information.
PAN INVERT - In this submenu you can activate pan inversion.
TILT INVERT - In this submenu you can activate tilt inversion.
BACK LIGHT - In this submenu you can have the display backlight turn o after a minute of no acitivty.
AUTO TEST - In this submenu you can run an auto test of the functions.
LED TEMP. (TEMPERATURE) - In this submenu you can check the current running temperature.
FIXTURE TIME - In this submenu you can check the xture running time.
FIRMWARE VERSION - In this submenu you can check the current software version.
FACTORY RESTORE - In this submenu you restore the factory (default) settings.
RESET - In this submenu you can reset the motors.