ADJ Quad Phase HP - Page 10

Quad Phase HP System Menu
ADDR - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until "ADDR" is displayed, press
ENTER.
2. "1" will now be displayed and ashing. Press the UP or DOWN buttons to nd your
desired address. Press ENTER to set your desired OMX address.
SCnd - This will let you set unit as a Pri or Sec in a Primary/Secondry conguration.
1. Press the MENU button until "SCND" is displayed, then press ENTER. "PrI", "SEC1"
or "SEC2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is displayed, press ENTER to
conrm and exit.
SOUN - Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select
"ON" to activate sound active mode, or "OFF" to deactivate sound active mode.
3. Press ENTER to conrm.
SENS - Using this mode, you can set the sound sensitivity level. 0 for least sensitive, 100
for more sensitive.
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. Using the UP or DOWN buttons adjust the sensivity level to your desire.
3. When you found your desired level, press the ENTER, and then press and hold the
MENU button for at least 3 seconds to conrm.
DNST - This mode can be used as a precaution mode, that in case the DMX signal
is lost, the operating mode chosen in the setup is the running mode the xture will
go into when the DMX signal is lost. You can also set this as the operat- ing mode
you would like the unit to return to when power is applied.
1. Press the MENU button until “DNST” is displayed press ENTER.
2. Either “Pr Se”, “BLND”, or “LAST” will be displayed. Choosean operating mode you
would like the unit to start up when power is applied or the DMX signal is lost.
• Pr Se (Primary/Secondry) - If the DMX signal is lost, or power is applied, the
unit will automatically go into Primary Secondry mode.
• BLND (Blackout) - If the DMX signal is lost or power is applied, the unit will
automatically go into stand by mode.
• LAST (Last State) - If the DMX signal is lost the xture will stay in the last DMX set
up. If power is applied and this mode is set, the unit will automatically go into the
last DMX set up.
3. Press ENTER to conrm your desired set up.
ADJ Products, LLC - www.adj.com - Quad Phase HP - User Manual - Page 10