Need help?Do you have a question about the ADJ UB 12H and is the answer not in the manual?
Requirements for DMX data cables for proper operation and connectivity.
Instructions for turning the LED display on/off and inverting its orientation.
How to select and adjust colors and strobing in Static Color mode.
Adjusting intensity of individual colors (Red, Green, Blue, White, Amber, UV) and strobing.
Setting fade speed and flash for automatic programs.
Selecting, setting speed, fade, and flash for 22 built-in programs.
Adjusting sound sensitivity and flash settings for sound-reactive operation.
Selecting DMX address and channel modes (6, 10, 12, 36 Channel).
Enabling or disabling the IR sensor for remote control via ADJ UC IR.
Defining fixture behavior upon DMX signal loss (Blackout, Last State, Auto Run).
Selecting different dimming curve profiles (Standard, Stage, TV, Architectural, Theatre).
Resetting the unit to default settings and running an auto program.
Linking units in a primary-secondary setup using XLR data cables.
Troubleshooting steps for DMX connectivity issues and dimmer channel settings.
Troubleshooting steps for issues with sound-activated mode responsiveness.
Requirements for DMX data cables for proper operation and connectivity.
Instructions for turning the LED display on/off and inverting its orientation.
How to select and adjust colors and strobing in Static Color mode.
Adjusting intensity of individual colors (Red, Green, Blue, White, Amber, UV) and strobing.
Setting fade speed and flash for automatic programs.
Selecting, setting speed, fade, and flash for 22 built-in programs.
Adjusting sound sensitivity and flash settings for sound-reactive operation.
Selecting DMX address and channel modes (6, 10, 12, 36 Channel).
Enabling or disabling the IR sensor for remote control via ADJ UC IR.
Defining fixture behavior upon DMX signal loss (Blackout, Last State, Auto Run).
Selecting different dimming curve profiles (Standard, Stage, TV, Architectural, Theatre).
Resetting the unit to default settings and running an auto program.
Linking units in a primary-secondary setup using XLR data cables.
Troubleshooting steps for DMX connectivity issues and dimmer channel settings.
Troubleshooting steps for issues with sound-activated mode responsiveness.
Power| voltage | 100V ~ 240V / 50~60Hz |
|---|---|
| power draw | 85W |
| fuse | 2 Amp |
Lighting Specifications| LEDs | 12 x 6W 6-in-1 HEX LEDs |
|---|---|
| beam angle | 40 Degrees |
| color mixing | RGBWA+UV |
Weight and Dimensions| weight | 6 lbs / 2.7 kg |
|---|---|
| length | 41.75 inches / 1060 mm |
| width | 2.5 inches / 63 mm |
| height | 3.75 inches / 90 mm |
To Next Page
