ADJ Products, LLC - www.adj.com - UB 6H User Manual Page 10
UB 6H Operating Instructions
RGBWA & UV Dimmer Mode:
1. Plug the fixture in and press the MODE button until “r.XXX” is displayed. You are in Red dimming
mode.
2. Press the UP and DOWN buttons to adjust intensity. After you have finished adjusting the inten-
sity, or if you would like to skip to the next color, press the SET UP button.
3. When “G.XXX” is displayed you are in Green dimming mode. Press the UP and DOWN buttons to
adjust intensity.
4. When “b.XXX” is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to
adjust intensity.
5. When “U.XXX” is displayed you are in White dimming mode. Press the UP and DOWN buttons to
adjust intensity.
6. When “A.XXX” is displayed you are in Amber dimming mode. Press the UP and DOWN buttons to
adjust intensity.
7. When “u.XXX” is displayed you are in UV dimming mode. Press the UP and DOWN buttons to
adjust intensity.
8. After you have adjusted the colors to make your desired color you can then activate strobing by
pressing the SET UP button to enter the strobe mode.
9. “FSXX” will be displayed, indicating that the device is now in strobe mode. The strobe can be
adjusted between “00” (flash off) to “15” (fastest flash).
Auto Run Mode:
In this mode the fixture will run an auto program.
1. Plug the fixture in and press the MODE button until “AUTO” is displayed.
2. After you have activated Auto Run mode, press the SET UP button to adjust the fade time.
3. Once you press SET UP “Fd.XX” should be displayed. Use the UP or DOWN buttons to set the
fade speed to either “Fd.00” (fade off) or between “Fd.01” (fastest speed) and “Fd.99” (slowest
speed). After adjusting the fade speed, press SET UP if you wish to activate the Flash mode.
4. “FS.XX” will now be displayed, indicating that the device is now in Flash mode. The Flash can be
adjusted between “FS.00” (flash off) to “FS.15” (fastest flash).
To Next Page
