ADJ Products, LLC - www.adj.com - UB 6H User Manual Page 9
UB 6H Operating Instructions
LED Display On/Off:
To set the LED display to turn off after 10 seconds of inactivity, press the MODE button until “don” is
displayed, then press the UP button until “doff” is displayed on the screen. Now the display will turn
off after 10s. Press any button to turn the display on again.
LED Display Inversion:
Follow these instructions to flip the display 180° so that the display can be read when the unit is
mounted upside down.
1. Plug the fixture in and press the MODE button until “dXX” is displayed. “XX” represents either
“on” or “oFF”.
2. Press the SET UP button until “Stnd” is displayed.
3. Press the UP or DOWN buttons to “flip” the display 180°.
Operating Modes:
The UB 6H has six operating modes:
• Static Color Mode - There are 63 colors to choose from.
• RGBWA+UV Dimmer Mode - Choose one of the 6 colors to remain static, or adjust the intensity
of each color to create a custom color.
• Built-In Program - There are 22 built-in programs to choose from with multiple adjustments.
• Auto Run - An auto program will run with adjustable fade speed and strobe.
• Sound-Active mode - The unit will react to sound, chasing through the built in programs.
• DMX control mode - This function will allow you to control each DMX trait with a standard DMX
512 controller.
Static Color Mode:
1. Plug the fixture in and press the MODE button until “CLXX” is displayed.
2. There are 63 colors to choose from. Select your desired color by pressing the UP and DOWN
buttons. After you have selected your desired color you can activate strobing by pressing the
SET UP button to enter the Flash (strobe) mode.
3. “FS.XX” will now be displayed, indicating that the device is now in Flash mode. The Flash can be
adjusted between “FS.00” (flash off) to “FS.15” (fastest flash).
To Next Page
Loading...
