Achtung:
The initial installation of this device can only be performed by using the RJ45
interface labelled with HOST.
A RJ45 PATCH CABLE IS REQUIRED FOR INITIAL CONFIGURATION.
Connecting the 24 V DC power source
The power for this device can be supplied by a 24V DC (2-pin connector) power supply. The
corresponding COMBICON connector is included in the scope of delivery.
Connect the device with a suitable power supply unit.
RJ45 network cable connection
For initial installation it is essential to establish a connection between this device and a PC by using a
RJ45 network cable.
To connect the device with a PC:
Device HOST connector <-> PC LAN connector
To Next Page
Loading...
