ADS-tec IF1100 - Operational LED Status Display; Power Supply; Cut & Alarm; LAN-IN

IF1000 series 29
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • D-72622 Nürtingen
5.5 Operational LED Status Display
The boot-up process starts as soon as the firewall is supplied with a voltage source. With the aid of the
Lan-in LEDs it is possible to check whether the Firewall is booting up as well. The table herunder
provides boot-up process LED blink frequency via which it is possible to check that the device is booting
up correctly. In the example, no LAN-in cable / PoE is connected up.
The minute the traffic display comes up on the LCD, the boot up process has been successfully
concluded.
State of theLED
representation
aus
grün
grün blinkend
rot
orange
orange blinkend
5.5.1 Power Supply / Cut & Alarm / LAN-IN
Abb.
5
:
POWER
Signal
Action
L+
The device is not supplied
with a power.
L+
The device is provided with
voltage via POWER and is
ready for operation.
BACKUP
Signal
Action
The device is not supplied
with a backup power.
The device is provided with
voltage via POWER and is
ready for operation.