Mounting a Backbox (SBB-X3 and ADT-CAB-400AA)
,QVWDOODWLRQ
Unimode 400 Installation PN 50710:A 10/22/97 2-7
0RXQWLQJD%DFNER[6%%;DQG$'7&$%$$
This section provides instructions for mounting an SBB-X3 or ADT-CAB-400AA
backbox. Follow these guidelines when mounting a backbox:
&DXWLRQ
8QOHVV \RX DUH IDPLOLDU ZLWK WKH SODFHPHQW RI FRPSRQHQWV ZLWKLQ WKLV EDFNER[
RQO\ XVH WKH NQRFNRXW ORFDWLRQV SURYLGHG IRU FRQGXLW HQWU\
• Mount a backbox on a surface in a clean, dry, vibration-free area. Install the
cabinet by following the instructions in Table 2-4.
• Locate the backbox so that the top edge is 66 inches above the surface of the
finished floor.
• Mount the backbox using the four mounting holes in the back surface of the
backbox.
)LJXUH 0RXQWLQJ D &DELQHW %DFNER[
Table 2-4 Mounting a Cabinet Backbox
Step Action
1 Mark and pre-drill holes for the top two keyhole mounting bolts.
2 Install two upper fasteners in the wall so the screw heads protrude approximately
1/2".
3 Using the keyholes, mount the backbox over the two screws.
4 Mark the two holes, remove the backbox and drill the mounting holes.
5 Mount the backbox, then install and tighten the remaining fasteners.
0RXQWLQJ KROHV
SODFHV
.H\KROHV
SODFHV
To Next Page
Loading...
