ADT Unimode 400 Multi-Net - Page 46

 ,QVWDOODWLRQ Mounting an MPS-400 Power Supply
2-8 Unimode 400 Installation PN 50710:A 10/22/97
0RXQWLQJDQ0363RZHU6XSSO\
0RXQWLQ
J
DQ036LQWRDQ$'7&$%;&DELQHW
This section contains instructions for mounting an MPS-400 into an ADT-CAB-X3
(Figure 2-9 and Figure 2-10) and for mounting an MPS-400 into an ADT-CAB-400AA
(Figure 2-11).
The MPS-400 mounting assembly consists of the MPS-400 module attached to
mounting chassis. To install the MPS-400 into ADT-CAB-A3, ADT-CAB-B3,
ADT-CAB-C3, or ADT-CAB-D3 cabinets, follow these steps.
1. Place the MPS-400 assembly into the cabinet so the MPS-400 chassis bracket
engages the support bracket on the cabinet as shown in Figure 2-9:
)LJXUH  3ODFLQJ DQ 036 RQWR D 6XSSRUW %UDFNHW
2. Secure the bottom of the MPS-400 to the bottom cabinet support with the
mounting screws as shown in Figure 2-10:
)LJXUH  0RXQWLQJ DQ 036 LQWR DQ $'7&$%;
036 FKDVVLV
EUDFNHW
$'7&$%; VXSSRUW
EUDFNHW
036 $VVHPEO\
&$%; &DELQHW
0RXQWLQJ VFUHZV