To Next PageTo Next Page
Need help?Do you have a question about the ADT ADT-LCD40 and is the answer not in the manual?
General| Brand | ADT |
|---|---|
| Model | ADT-LCD40 |
| Category | Control Panel |
| Language | English |
Critical precautions for safe and correct system installation, including power disconnect and testing.
Regulatory information regarding radio frequency emissions and compliance for the device.
Details Canadian regulatory compliance for digital apparatus radio emissions.
Details features and differences between the ADT-LCD40 and ADT-LCD40L annunciator models.
Explains the function and settings of the SW1 DIP switch for annunciator operation.
Illustrates how the ADT-LCD40 Series annunciators are connected within a typical fire alarm system.
Covers the various messages and patterns displayed on the annunciator's LCD screen.
Details the operation of the Acknowledge, Silence, Drill, and Reset switches on the ADT-LCD40.
Explains the function and meaning of the Power, Alarm, Trouble, and Supervisory LEDs.
Outlines steps for preparing the annunciator for mounting, including trim ring removal.
Provides instructions for mounting the annunciator semi-flush within a three-gang electrical box.
Provides instructions for mounting the annunciator surface-mount within a three-gang electrical box.
Details the connection of the 24 VDC power supply to the ADT-LCD40 Series annunciator.
Describes how to connect the EIA-485 serial interface for communication with the control panel.
Explains the wiring connections for the DIM-485 module used with the annunciator.
Outlines the procedure for installing the DIM-485 module onto the Unimode 200 circuit board.
Details the proper termination of EIA-485 cable shields when not installed in conduit.
Details the proper termination of EIA-485 cable shields when installed in conduit.
