To Next PageTo Next PageWhat to do if POTS LED is red on ADTRAN Network Hardware?
If the POTS LED on your ADTRAN Network Hardware is red, first contact the OLT administrator to ensure the port is provisioned and working. Next, disconnect the CPE wiring for 30 seconds; if the LED turns off, there's likely a short in the housing wiring. If the LED remains red, the unit might be faulty.
What to do if LEDs on the front of ADTRAN SFU ONT Network Hardware cycle continuously?
If the LEDs on the front of your ADTRAN SFU ONT Network Hardware cycle continuously, try using a different SFU ONT. Also, ensure that the power supply is functioning correctly.
Why is the network status LED red on my ADTRAN Network Hardware?
If the network status LED on your ADTRAN Network Hardware is red, contact the Central Office. There may be a software configuration issue between the OLT and the SFU ONT.
How to fix network status LED off on ADTRAN Network Hardware?
If the network status LED on your ADTRAN Network Hardware is off, check all fiber connections to make sure they are clean and tight.
What to do if the upstream optical signal level is out of range on ADTRAN Network Hardware?
If the upstream optical signal level is out of range on your ADTRAN Network Hardware, first verify the ONT provisioning at the OLT. If the problem persists after verification, consider replacing the ONT.
What to do if network status LED continually flashes yellow on ADTRAN Network Hardware?
If the network status LED on your ADTRAN Network Hardware is continually flashing yellow, contact the Central Office.
General| Brand | ADTRAN |
|---|---|
| Model | Total Access 362R |
| Category | Network Hardware |
| Language | English |
Lists standard technician tools and specific items required for ONT installation, including levels, screwdrivers, crimpers, test sets, and optical tools.
Details steps for securely mounting the outdoor ONT enclosure to a vertical surface, ensuring proper leveling and fastener usage.
Provides instructions for establishing a proper earth ground connection for the outdoor ONT, including wire routing and termination.
Explains how to correctly connect the power and alarm wiring to the ONT's electronics module, emphasizing proper connector handling.
Guides on routing the OptiTap fiber drop cable through the housing, ensuring it's not pinched when the module is closed.
References the installation guide for complete information on connecting the SC/APC optical cable using a bulkhead adapter.
Advises on local power source wiring, deferring to the installation guide for specific on-site conditions and practices.
Refers to the installation guide for UPS installation procedures, which depend on site conditions and local practices.
Details connecting POTS (Plain Old Telephone Service) using two-screw terminal bridges or RJ-11 jacks.
Instructs on routing the RF cable through the enclosure and connecting it to the RF connector on the electronics module.
Explains connecting CAT-6 rated Ethernet cables for Gigabit operation to the RJ-45 ETH socket on the ONT.
Provides guidance on selecting a location for the indoor ONT and mounting it, recommending below eye-level for visibility.
Details creating and connecting POTS cables to the indoor ONT's RJ-11 jacks, using an RJ-11 crimper.
Explains connecting CAT 5 or 6 rated cables to the NET connection for the indoor ONT's Gigabit Ethernet ports.
Instructs connecting a standard male F-type connector coaxial cable to the RF connection on the indoor ONT.
Refers to the installation guide for details on connecting the external power supply to the indoor ONT.
Details the meaning of LED indicators for Power, Network Status (OLT connection, ranging), and POTS status (off-hook, ringing).
Lists critical operating parameters including voltage range, power consumption for various models, and optical transmit/receive specifications.
States that ONTs require no routine hardware maintenance and advises against field repairs, recommending returns for service.
Directs users to specific guides for Safety and Regulatory Compliance information pertaining to individual ONT models.
