CONFIGURE...
The first menu item reads
CONFIGURE... [NEXT/OK]
[NEXT/OK] is a visual reminder that pressing
the left side of the rocker switch will go to the
next menu item, and that pressing the right
side of the rocker switch will select the cur-
rent option.
Press OK (right side) to access the
Configuration Menu.
*** SETUP MENU ***
CONFIGURE... [NEXT/OK]
*** CONFIGURATION MENU ***
*** CONFIGURATION MENU ***
LOAD DEFAULTS [NEXT/OK]
COLS=32 [NEXT/OK]
INVERT=NO [NEXT/OK]
FONT=5X8 [NEXT/OK]
MAG=NONE [NEXT/OK]
Ready...
Configuration parameters are described
below.
Cols
Use this parameter to set the number of char-
acters (columns) per line. Choices are 24, 32,
or 40 (the larger numbers represent a smaller,
more condensed appearance).
Invert
Use this parameter to change the orientation
of text in your printouts. Choose YES if you
want inverted (upside down) text, or NO if
you want non-inverted (right-side up) text.
Font
Choose from a 5 x 5 or a 5 x 8 dot matrix
print pattern. The 5 x 5 dot matrix pattern
produces only uppercase (capital) letters.
Mag
Magnification refers to the size of printed
type from your printer. Choices are:
NONE
Double Wide
Double High
Double Wide/High
After choosing a magnification, the printer
will print Ready... to show that the printer is
out of the Configuration Menu and the Setup
Menu, and is ready to print.
CUSTOM...
The second Setup Menu item reads
CUSTOM... [NEXT/OK]
Press OK (right side) to access the Custom
Menu.
*** SETUP MENU ***
CONFIGURE... [NEXT/OK]
CUSTOM... [NEXT/OK]
****** CUSTOM MENU ******
PRINT CUSTOM SETUP [NEXT/OK]
Press OK (right side) to print the current
Custom setup. A sample printout follows.
4MP540 Rev3
(4D35SM)
Page 5 of 7
To Next Page
Loading...
