4MP540 Rev3
(4D35SM)
Page 6 of 7
*** SETUP MENU ***
CONFIGURE... [NEXT/OK]
CUSTOM... [NEXT/OK]
****** CUSTOM MENU ******
PRINT CUSTOM SETUP [NEXT/OK]
AUTO SEQ=YES [NEXT/OK]
ZERO=0 [NEXT/OK]
POUND SIGN=# [NEXT/OK]
_(Underscore) [NEXT/OK]
BUSY INVERT=NO [NEXT/OK]
ONLINE/OFFLINE=YES [NEXT/OK]
XON/XOFF 90/10 [NEXT/OK]
EXT CH SET=NO [NEXT/OK]
PRINT READY=YES [NEXT/OK]
Ready...
Customization parameters are described
below.
Auto Seq#
NO - Don’t autoprint sequence number after
CR (carriage return).
YES - Autoprint sequence number after CR.
Zero
Choose how you want the zero character to
look in your printouts -- with or without a
slash through the character.
Pound Sign
Choose to show pound as # symbol, or as the
British Sterling £ pound symbol.
_Underscore
Choose which symbol the same ASCII code
will print -- an _underscore, or a left arrow.
Busy Invert
NO - Voltage will be in a high state until the
unit is busy, then voltage level goes
low.
YES - Voltage will be in a low state until the
unit is busy, then voltage level goes
high.
Online/Offline
YES - Enables the rocker switch to turn the
printer offline.
NO - Disables the Online/Offline option.
Ext Ch Set
The option to use the extended character set is
available only when 8 data bits are chosen.
YES - Allows you to use hexadecimal num-
bers above 80 (true only for 8 data
bits).
NO - Disables the Extended Character Set
option.
Print Ready
YES - Prints Ready... upon power up.
NO - Disables printing Ready...
WARNING:
If you choose NO, hold down the left
side of the rocker switch for 4-6 sec-
onds to access the Setup Menu. Begin
timing when you plug in the unit and
the red light comes on. The paper
feed motor does not run upon power-
up when Ready... is disabled.
RESET SEQ#...
The third Setup Menu item reads
RESET SEQ#... NEXT/OK]
This menu option allows you to reset the
sequence number, which is the number of
print transactions since the last reset.
To Next Page
Loading...
