Chapter 4 Command Set 4-163
4050, 4052, 4053, 4060, 4051, 4055, 4068
Chapter 4
$AA5
Name Reset Status command
Description Requests the Reset Status of the addressed digital I/O module
to see whether it has been reset since the last Reset Status
command.
Syntax $AA5(cr)
$ is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address of the analog output module whose Reset Status is to
be returned.
5 is the Reset Status command.
(cr) is the terminating character, carriage return (0Dh).
Response !AAS(cr) if the command was valid.
?AA(cr) if an invalid command has been issued.
There is no response if the module detects a syntax error or
communication error or if the specified address does not exist.
!
delimiter character indicating a valid command was received.
?
delimiter character indicating the command was invalid.
AA (range 00-FF) represents the 2-character hexadecimal
address of the digital I/O module that is calibrated.
S represents the Status bit that is returned by the digital I/O
module. If S=1, the module has been reset since the last time it
was issued. If S=0, the module has not been reset since the last
Reset Status command was issued.
(cr) is the terminating character, carriage return (0Dh).
To Next Page
Loading...
Need help?
General
