Appendix D Utility Software D-5
Appendix D
File
This option allows you to update the status field and can gives you a
hardcopy of all the connected modules that are shown on the screen. You
can also print this information.
Terminal
This option allows you to directly send and receive commands on the RS-
485 line. It has two options: Command Test and Terminal Emulation.
With Command Test you send commands one at a time by typing them into
the top blank and pressing <Enter>. The response appears in the bottom
blank. To send the command again, simply press <Enter> again.
Figure D-3
Zero Calibration
To Next Page
Loading...
Need help?
General
