UTC-318 User Manual 10
2.2 Installation Procedures
2.2.1 Connecting the Power Cord
UTC-318 can be powered by a DC electrical outlet. When handling power cords,
ensure to only hold the plug ends. Please refer to Figure 2.3 when connecting the
male plug of the power cord to the UTC-318 DC inlet.
2.2.2 Connecting a Keyboard or Mouse
Before powering on the device, connect a keyboard or mouse to the relevant port in
the I/O section.
2.2.3 Switching on the Power
The power button is located at the rear of the UTC-318, as shown in Figure 2.3.
Figure 2.3 Connecting the Power Cord to the DC Inlet
To Next Page
Loading...
