AED IONOMAT 1 - 4 Unpacking the Device and Switching on the Device; 5 Hand Perspiration Treatment; 6 Treatment of Foot Tranpiration

IONOMAT 1
Page 6 sur 14
4 Hand perspiration treatment
1) Place on a coffee table: the generator in the middle,
On the left is a tray with the electrode covered with the biocompatible grid.
On the right the other tank with the electrode covered with the biocompatible grid.
2) Connect the electrodes to the cables with the clamps to the generator,
3) Plug in the generator, the green LED lights up and you read 00.0
Pour about 2 cm of water into the bins. (hands must not be fully immersed).
Sit comfortably on a chair in front of the table.
4) Adjust the current to the supported value according to the table of recommended values, start
with the minimum value, gradually increase over the sessions until the maximum value is easily
supported).
5) Turn the right knob to "IONO 20" and put your hands in the water immediately.
6) After 15 seconds, the current rises slowly and then stabilizes. It cancels out after 10 minutes
and then slowly increases again as it reverses.
7) After 20 minutes the device rings, you can then remove your hands and stop the ringing by
setting the right button to 0.
You can stop the treatment at any time by gradually removing the extremities
and finishing with a palm.
During the first use, it is recommended to use 20min to determine the
effectiveness of the treatment, switch to the 30 mn position in case of insufficient
effectiveness.
Children (From 7 years
old)
Women
Men
HANDS
2 à 8 mA
5 à 20 mA
8 à 25 mA
Frequency of sessions: In attack treatment 3 to 5 sessions the first week, then 2 sessions per week for
4 weeks and 1 maintenance session per week all year round.
Treatment of foot tranpiration
1) Place on a coffee table: the generator.
Place 1 tray on the floor on the left with the electrode covered with the biocompatible grid.