IONOMAT 1
Page 7 sur 14
Place the other tray on the right side of the floor with the electrode covered with the
biocompatible grid.
2) Connect the electrodes to the cables with the clamps to the generator,
3) Plug in the generator, the green LED lights up and you read 00.0
Pour about 2 to 3 cm of water into the bins. (The feet should not be fully submerged).
Sit comfortably on a chair in front of the table.
4) Adjust the current to the supported value according to the table of recommended values, start
with the minimum value, gradually increase over the sessions until the maximum value is easily
supported)
5) Turn the right knob to "IONO 20" and put your feet in the water.
6) After 10 seconds, the current rises slowly and then stabilizes. It cancels out after 10 minutes and
then slowly increases again as it reverses.
7) After 20 minutes the device rings, you can then remove your hands and stop the ringing by
setting the right button to 0.
You can stop the treatment at any time by gradually removing the ends and ending with
the heel, or reset with the current adjustment knob.
During the first use, it is recommended to use 20min to determine the effectiveness of
the treatment, switch to the 30 mn position in case of insufficient effectiveness.
Frequency of sessions: In attack treatment 3 to 5 sessions the first week, then 2 sessions per week for
4 weeks and 1 maintenance session per week all year round.
7 Underarm perspiration treatment
1) Connect the alligator clips to the width of the stainless steel armpit electrodes.
2) Thread the stainless steel underarm electrodes into the biocompatible sponges when
wet thoroughly.
3) Hold them under the arms horizontally, letting the crocodile clip extend well beyond
the arms, which should not touch the skin.
To Next Page
Loading...