Operating the Oven40
Clock Functions
MINUTE MINDER
To set a countdown. A signal sounds after the time has elapsed.
This function does not affect the operation of the oven.
DURATION
To set how long the oven is to be in use.
END
To set when the oven is to switch off again.
TIME OF DAY
To set, change or check the time
(See also section “Before Using for the First Time”).
Information about the clock functions
• After a clock function has been selected, the corresponding symbol flashes for
about 5 seconds. During this time, the desired times can be set or modified us-
ing the or button.
• When the desired time has been set, the corresponding symbol continues to
flash for approx. 5 seconds. After this the symbol lights up. The set time begins
to run.
2 Using residual heat with the DURATION and END
clock functions.
When the DURATION and END clock functions are used, the oven switch-
es the heating elements off, when 90% of the time set or calculated has elapsed.
The residual heat present is used to continue the cooking process until the time
set has elapsed (3 to 20 mins.).
3 The clock functions display shows the period of operation for the selected
oven function, if none of the clock functions MINUTE MINDER ,
DURATION or END is set.
To Next Page
Loading...
