AEG BS 45 E - Trouble-shooting; No Hot Water Despite Flow Volume Setting; Unit Not Working with Available Supply; ELSD Light On

10
3. Guarantee
4. Trouble-shooting
For guarantees please refer to the respec-
tive terms and conditions of supply for
your country.
The installation, electrical
connection and rst operation of
this appliance should be carried out by a
qualied installer.
The company does not accept liability
for failure of any good supplied which
have not been installed and operated
in accordance with the manufacturer’s
instructions.
Fault Cause Solution
No hot water despite
ow volume setting at
right-hand stop.
The water ow volume required
for the unit to turn on has
not been reached.
- The shower head is
blocked with dirt or
limescale.
- Flow volume too low
- Clean shower head
- Increase ow volume.
The unit is not working.
Electricity supply and
ow available.
The water ow volume
required for the unit to turn
on has not been reached.
- Filter in the cold water
connection pipe blocked
with dirt.
- Water pressure not
enough
- Clean the lter after shut-
ting o the cold water
intake
- Increase mains pressure
“ELSD” Light on - The safety device
activated.
- Press “Reset” button