• Always use cookware with a clean
base.
• Scratches or dark stains on the
surface have no effect on how the hob
operates.
• Use a special cleaning agent suitable
for the surface of the hob.
• Always use a scraper recommended
for hobs with a glass surface. Use the
scraper only as an additional tool for
cleaning the glass after the standard
cleaning procedure.
WARNING!
Do not use knives or any
other sharp, metal tools
to clean the glass
surface.
The printing on the flexible
induction cooking area may
become dirty or change its
colour as an effect of moving
the cookware. You can clean
the area in the described
way.
9.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, salt, sugar and food with
sugar, otherwise, the dirt can cause
damage to the hob. Take care to
avoid burns. Use a special hob
scraper on the glass surface at an
acute angle and move the blade on
the surface.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and a non-abrasive
detergent. After cleaning, wipe the
hob dry with a soft cloth.
• Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
9.3 Cleaning the hood
Grid
The grid guides the air into the hood.
Additionally, it protects the hood system
and prevents foreign objects from falling
inside by accident. You can wash the
grid manually or in a dishwasher. Wipe
the grid with a soft cloth.
Water tank
There is a water tank located under the
hood. It collects the condensation
created during each cooking process. At
any time water might be dripping from
the hood system into the water tank.
Remember to empty the water tank
regularly.
Before you open the water tank, place a
container or a tray under it to collect
water.
1. To open the water tank, slide the
latches out and open them one by
one.
2. Dispose of the water and rinse the
water tank out.
WARNING!
Make sure no liquid gets
inside the hood.
If water or other liquids spill inside the
hood system:
1. Switch off the hood.
2. Lift the grid and clean the hood area
carefully with a moist cloth or sponge
and a mild cleaning agent.
3. Wipe away the excess liquid
gathered on the bottom of the hood
cavity using a sponge or a dry cloth.
4. Clean the filter, if needed (refer to
"Cleaning the hood filter").
5. Empty the water tank, if needed.
6. Switch on the hood, set the fan
speed level to 2 or higher and let it
run for some time to get rid of the
remaining moisture.
9.4 Cleaning the hood filter
The 2-in-1 long life carbon filter
combines the filtration of grease and
odour in one unit. The filter consists of
www.aeg.com24
To Next Page
Loading...
