Problem Possible cause Remedy
You can hear a constant
beep noise.
The electrical connection is
incorrect.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the in‐
stallation.
You cannot select the
maximum heat setting for
one of the cooking zones.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
Reduce the heat setting of the
other cooking zones connec‐
ted to the same phase. Refer
to "Power management".
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
You put something on one or
more sensor fields.
Remove the object from the
sensor fields.
The hob deactivates. You put something on the
sensor field .
Remove the object from the
sensor field.
Residual heat indicator
does not come on.
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
If the zone operated sufficient‐
ly long to be hot, speak to an
Authorised Service Centre.
There is no sound when
you touch the panel sen‐
sor fields.
The sounds are deactivated. Activate the sounds. Refer to
"Daily use".
The flexible induction
cooking area does not
heat up the cookware.
The cookware is in a wrong
position on the flexible induc‐
tion cooking area.
Place the cookware in the cor‐
rect position on the flexible in‐
duction cooking area. The po‐
sition of the cookware de‐
pends on the activated func‐
tion or function mode. Refer to
"Flexible induction cooking
area".
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Use cookware with a diameter
applicable to the activated
function or function mode. Re‐
fer to "Flexible induction cook‐
ing area".
The indicator above the
symbol comes on.
Child Safety Device or Lock
operates.
Refer to "Child Safety Device"
and "Lock".
The control bar blinks. There is no cookware on the
zone or the zone is not fully
covered.
Put cookware on the zone so
that it fully covers the cooking
zone.
ENGLISH 27
To Next Page
Loading...
