AEG DDLE Basis 11 - Power Supply; Completing the Installation; Commissioning

27
s Never replace the pressure limiter when using a thermostatic valve.
s Never use the shut-off valve in the cold water supply (23) to reduce the fl ow rate.
3.7 Power supply
s #ONNECTTHEPOWERCABLETOTHETERMINALSTRIPSEEWIRINGDIAGRAM
I
).
1 heating system
2 High limit safety cut-out
3 Safety pressure limiter
Important information:
s The protection level IP 25 (hoseproof) is only assured if the cable grommet is fi tted correctly (
G
or
K
)
and if the cable sheath is sealed correctly.
s Connect the equipment to earth.
s For supply cables > 6 mm², increase the hole in the cable grommet.
3.8 Completing the installation
Click the lower part of the back panel (
E
3) into place.
3.9 Commissioning (only by a qualifi ed contractor)
1
 &ILLANDVENTTHEDEVICE0LEASENOTE"OILDRYRISK
Open and close all connected taps several times, until all air
has been vented from the pipework and the equipment.
Air - see "2.3 Important information".
2
 !CTIVATETHESAFETYPRESSURELIMITER!0
The instantaneous water heater is delivered with the safety
pressure limiter triggered (press the reset button).
3
 0USHTHETEMPERATURESELECTORCABLEPLUGONTOTHE
ELECTRONIC0#"
4
 &ITANDAUDIBLYLETTHEDEVICECAPCLICKINTOPLACE
Check the fi rm seat of the device cap on the back panel.
5
 3WITCHONTHEMAINSPOWER
6
 4URNTHETEMPERATURESELECTORASFARASPOSSIBLECLOCKWISE
ANDANTICLOCKWISEWHICHCALIBRATESTHETEMPERATURE
7
 #HECKTHEINSTANTANEOUSWATERHEATERFUNCTION
Optional displays of the “traffi c light” indicators (
A
9), see also
“7. Troubleshooting”):
red illuminates in case of faults
yellow illuminates when the equipment is heating water
green fl ashing - equipment is supplied with mains power
%QUIPMENTHANDOVER
Explain the equipment function to the user and familiarise the user
with its operation.
)MPORTANTINFORMATION
s )NFORMTHEUSEROFPOTENTIALHAZARDSSCALDING
s (ANDOVERTHESEINSTRUCTIONSTOTHEUSERFORSAFEKEEPING
1
4
5
2.
1.
L
L
3
L
3
’
4
L
2
’
1
L
1
’
2
MV
NT C
T- soll
X1 1
18
21
24
k
W
6
C26_02_02_0769
3
2
For contractors