AEG ELFAMATIC uC 3000 - Controller Self-Test

29
English
For the Fitter
LCD Button
Button
Note
+
or
–
Display of the average outside temperature used for calculating
the charge.
The currently measured outside temperature value is entered in
the memory by holding down the
+
and
–
buttons
simultaneously for longer than 3 seconds.
Stored main release time
Stored additional-release time
Only for
Powertherm
charging
model
1.6 Controller self-test
The ELFAMATIC µC 3000 must be de-energised before the self-test can be started. Then press
the
+
and
–
buttons simultaneously and switch the power supply back on at the same time.
Display segment test Software version
LCD Button
Button
Bemerkung
+
or
–
Outside temperature
2x
Button test – An internal device test is performed to check
that the buttons are functioning correctly.
Press the
P
button. The buttons
+
,
–
and
M
were
already pressed during the self-test and therefore do not need
to be tested again.
EEP rom memory version
Output test – The relay and Triac can be activated alternately
by pressing the buttons
+
and
–
.
End – If no button is pressed for 2 seconds, the display returns
to the standard mode.
VR LF LZ KU
ED
SH
SYN
-20 8
AF M
°
C
,
P
P
P
VR LF LZ KU
ED
SH
SYN
LF
--
:
--
--
:
--
VR LF LZ KU
ED
SH
SYN
LZ
--
:
--
--
:
--
VR LF LZ KU
ED
SH
SYN
14
:
53
14
:
53
M
VR LF LZ KU
ED
SH
SYN
88
:
88
88
:
88
8888XXXX
,,
C
%
VR LF LZ KU
ED
SH
SYN
100
VERS
,
M
M
VR LF LZ KU
ED
SH
SYN
M
M
M
VR LF LZ KU
ED
SH
SYN
00
EEP
VR LF LZ KU
ED
SH
SYN
TAST
VR LF LZ KU
ED
SH
SYN
E/A
1A
VR LF LZ KU
ED
SH
SYN
-214
TEMP
°
C,
P
M