Accessories delivered with the
appliance may vary depending on the
model.
2. Put the packaging element on the floor
behind the appliance and carefully put it
down onto its rear side. Remove the
protection from the bottom.
CAUTION!
Do not lay washing machine on its front.
3. Put the appliance back into an upright
position. Remove the power supply cable
and the drain hose from the hose holders.
WARNING!
It is possible to see water flowing
from the drain hose. This is because
the washing machine has been
tested at the factory.
4. Remove the three bolts by using the key
supplied with the appliance. Pull out the
plastic spacers.
We recommend that you keep the
packaging and the transit bolts for any
transport of the appliance.
5. Put the plastic caps, that you find in the
user manual bag, in the holes.
5.2 Positioning and levelling
1. Install the appliance on a flat hard floor.
Make sure that carpets do not stop the
air circulation below the appliance.
Make sure that the appliance does not
touch the wall or other units.
2. Loosen or tighten the feet to adjust the
level.
ENGLISH 41
To Next Page
Loading...
